Pelican Case
Posted: February 2nd, 2020, 8:36 pm
Considering where we started... Previously used military case... pretty rough shape.
Now, I didn't fill in gauges or cuts, or even very indention out... but, I did put in considerable time removing years of stickers, decals, etc from the case... and then sanding the entire thing.
Followed by numerous types of "gray" color, Primer, etc....
In my mind, everything was too light... So I settled on something a few shades darker than the original.
Didn't take too many photos before or any during... but, below are how it turned out.
Used Rustoleums Coastal Gray for the color.
Ordered New foam from the pelican Ebay page... it was $40 for a complete new set.
Already have Flares for it... looking through extinguishers as well....
If only I could find a Maxa Light that wasn't $1200+
Now, I didn't fill in gauges or cuts, or even very indention out... but, I did put in considerable time removing years of stickers, decals, etc from the case... and then sanding the entire thing.
Followed by numerous types of "gray" color, Primer, etc....
In my mind, everything was too light... So I settled on something a few shades darker than the original.
Didn't take too many photos before or any during... but, below are how it turned out.
Used Rustoleums Coastal Gray for the color.
Ordered New foam from the pelican Ebay page... it was $40 for a complete new set.
Already have Flares for it... looking through extinguishers as well....
If only I could find a Maxa Light that wasn't $1200+