Pennsylvania Jeep #12

[Jack_Fauth]

can't wait to mess around with these tomorrow in the dark...!!!!

[mydigitalvoid]

Where did you mount the switches on the inside?

[Maverick20]

what about the inside of the light bar how did u stop rust?

[Jack_Fauth]

what about the inside of the light bar how did u stop rust?

I think the bar will be fine as it is, mine has zero rust on the inside.

as for mounting the switches i ran each lights wire through the hole in the back of the bar near each mounting tab.

then i drilled a 1" hole into of the side of the jeep that goes into the passenger compartment. Then i ran all 4 wire through a grommet and into the interior compartment.

Here you can see that i mounted the switches to the oh shit bar above the glove box
Ran all 4 light to the accessory switch in the fuse box under the dash. LightS all run indepently as they did in the movie

here is a photo of the switches mounted. I think i will get a blank cover to fill in the end and hide the rest of the wires

[Jack_Fauth]

MONEY SHOT......!!!!!!!!!!!!!

[fantomas]

Holy crap that looks great! When you test it out, let us know the actual functionality of those lights are.

On a side note, I've got that same Ikea lamp

[PaulRevere1991]

looks awsome

[Breven52]

I actually just had an idea for your glovebox delete pannel. you should try to do a Data plate for it. Until the late run of Cj5s, jeeps came with acid etched Data plates. I

here are some samples I made

[Jedigreedo]

Awesome work, Fauth! Looks fantastic!

And nifty idea, Breven.

[Maverick20]

cool nice light bar im powdercoating mine the only thing im a little lost on is how to wire the lights up. like relays fuses and all that.. i know how to do butt connectors and stuff like that. just dont undersatand the route and where i need to run it all. mine will be non-morotized 55w each 4 lights.