Page 1 of 1

JP36 WIP (This is going to take a while)

Posted: August 21st, 2019, 4:24 pm
by Tylermays1996
Recently traded my 1974 jeep J10 4.2 pick up for a 1988 jeep wrangler 4.2 that once was a Jp jeep.
This jeep had been sadly abused in the past and is going to require extensive body work and a new block due to rod knock and a split in the cooling jacket from age.
besides that and crappy after market gauges I hope to peace this thing together in next 2 years or sooner.
20190804_194725.jpg

Re: JP36 WIP (This is going to take a while)

Posted: August 26th, 2019, 5:03 am
by ratrace427
so many jp jeeps these days. did this belong to a member before?

Re: JP36 WIP (This is going to take a while)

Posted: August 27th, 2019, 3:33 pm
by Tylermays1996
ratrace427 wrote:so many jp jeeps these days. did this belong to a member before?
Yes! it was owned by two previews member before I got it.

Re: JP36 WIP (This is going to take a while)

Posted: September 2nd, 2019, 7:34 pm
by Tylermays1996
Tear down went smoothly for the most part but ran into gremlins that need to be addressed before I can continue.
-windshield frame rusted through
-cowling rusted through
-dents every where >.>
20190804_203940.jpg
Anyone have a factory gauge cluster that they wouldn't mind parting with for a 1988-1990?
20190804_205218.jpg
20190807_214050.jpg
20190807_211710.jpg

Re: JP36 WIP (This is going to take a while)

Posted: September 4th, 2019, 5:17 am
by ratrace427
oh no! when you said windshield frame i was thinking the glass section. Is that black piece on the glass section covering up rust? That looks like something that was slapped on over the rust. Lots of builds require a new frame but that rust on the dash side is another story.

Re: JP36 WIP (This is going to take a while)

Posted: May 13th, 2020, 10:26 pm
by Tylermays1996
Due to being out of work there has been quite the progress made on removing the engine and replacing rusty parts.
Image
Image

Out with the old in with a low mile AMC V8!
Image

Re: JP36 WIP (This is going to take a while)

Posted: May 14th, 2020, 4:46 pm
by Glissard
Wow, great progress so far.

Re: JP36 WIP (This is going to take a while)

Posted: May 15th, 2020, 12:53 pm
by Tylermays1996
New rust free windshield installed along with seat belts. ( waiting on assistance for the motor swap)
Image
Image

Re: JP36 WIP (This is going to take a while)

Posted: June 6th, 2020, 11:50 pm
by Tylermays1996
the motors all bolted in and time to mess with the rats nest of wiring the previous owner messed with. Image